Forge Motorsport Atmospheric Dump Valve for Ford Fiesta ST 180 Mk7

This valve is for the turbocharged 1.6-litre EcoBoost petrol engine found in the Fiesta ST. It is recommended for any vehicle where the boost pressure has or is going to be increased by an ECU software upgrade.

Our alternative is a fully engineered solution, offering significantly improved reliability. Our valve and installation kit replaces the original unit with a pressure/vacuum operated piston valve, that still also retains the desirable OEM ECU control over valve actuation. This product has been thoroughly designed and tested with the expressed intent of offering improved valve response and maintaining ECU control while resulting in absolutely NO fault codes, NO check engine lights, and no adverse effects of any kind. All of the necessary components and detailed instructions are included and everything is designed to make installation as simple as possible.

1 x FMBGFK4 Boost Tap and Bolt. 1 x Solenoid, Bracket and Screws.

1 x Blue Spring (Uprated). 1 x 2000mm Length of 4mm Vacuum Hose. 1 x Forge Key Ring and Sticker. Failure to supply this proof will result in your claim or enquiry being denied. Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator, or oil cooler. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water. If this is the case you will be contacted within 24 hours.

---