We recommend servicing your valve every 3 years, or 20,000 miles, whichever comes sooner This valve is for the turbocharged 1.6-litre EcoBoost petrol engine found in the Fiesta ST. It is recommended for any vehicle where the boost pressure has or is going to be increased by an ECU software upgrade, Our alternative is a fully engineered solution, offering significantly improved reliability.
Our valve and installation kit replaces the original unit with a pressure/vacuum operated piston valve, that still also retains the desirable OEM ECU control over valve actuation. This product has been thoroughly designed and tested with the expressed intent of offering improved valve response and maintaining ECU control while resulting in absolutely NO fault codes, NO check engine lights, and no adverse effects of any kind.All of the necessary components and detailed instructions are included and everything is designed to make installation as simple as possible. In The Box: 1 x FMDVST180 Valve 1 x FMBGFK4 Boost Tap and Bolt 1 x Solenoid, Bracket and Screws 1 x Blue Spring (Uprated) 1 x Wiring Harness 2 x Posi-taps 10 x Cable Ties 1 x 2000mm Length of 4mm Vacuum Hose 1 x Forge Key Ring and Sticker 1 x Instruction Booklet If you wish to tune this product to fit the needs of your engine, please see the spring tuning kit below. This item is in the category "Vehicle Parts & Accessories\Car Tuning & Styling\Air Intake & Induction\Performance Induction Kits". The seller is "wg_motorparts" and is located in this country: GB. This item can be shipped worldwide.